hitmanmcchitmanmcc
FeedConsolesCRTsSymptomsTechniquesLab

© 2026 Hitman's Museumv1.17.3

About·Privacy·Terms

Missing colour channel

One RGB channel entirely absent from the picture.

4 repair logs

Finger pointing to reflowed solder joint on Sony BVM neckboard, showing repaired connection that caused color loss.
+41 photos✓Successful repair

Sony — BVM-9045QD

Sony BVM-9045QD: Neckboard Joint Fix & Full Recap

Sony BVM-9045QD that arrived from Japan with an entire colour missing, the same broken neckboard solder joint that had plagued the PVM-14M4J. Full restoration followed: PSU, deflection board, colour board and anode cap all seen to.

Missing colour channelBulging capacitorsCold/dull solder joints
Jul 10, 20235 threads
Sony PVM-9040 CRT displaying color bars test pattern showing RED, GREEN, BLUE, and WHITE channels for diagnostics.
+45 photos✓Successful repair

Sony — PVM-9040

Sony PVM-9040 Triplets: Trim Pots Fix B&W Issue

Three 9-inch Sony PVM-9040s that arrived from Japan with customs drama. Monitors were fine inside, bar a known colour issue fixed by replacing the trim pots (which fixes the black-and-white-only fault). Full restoration across all three followed.

Missing colour channelCold/dull solder joints
Jun 22, 20236 threads
Sony PVM-14M4J displaying color bars test pattern showing red, green, and yellow bars with missing blue channel output during repair diagnostics.
+42 photos✓Successful repair

Sony — PVM-14M4J

Sony PVM-14M4J Trinitron: Retrace Lines & Colour Fix

Sony PVM-14M4J Trinitron with the common retrace lines issue, arrived with one colour completely missing. I made a mistake along the way but got there in the end. Trash to treasure.

Missing colour channelRetrace linesCold/dull solder joints
May 10, 20237 threads
Sinclair ZX Spectrum +2 (Issue 3): Dead RAM, Backwards Factory Transistors & ULA Bridge
+25 photos✓Successful repair

Sinclair — ZX Spectrum +2

Sinclair ZX Spectrum +2 (Issue 3): Dead RAM, Backwards Factory Transistors & ULA Bridge

The childhood ZX Spectrum +2 (grey, issue 3) stopped booting properly in 2021 with dead memory. All sixteen 4164 DRAMs were socketed and replaced, then the originals were sorted one at a time in a contended slot to find the bad ones. Recapped along with the PSU, 7805 replaced, the C31 audio bleed mod done, TR4, TR5 and TR7 reversed to correct a factory silkscreen error, and a solder bridge on the ULA cleared. C52 next to the ULA was later swapped for a 100uF radial and 1nF ceramics added across C72 to C79 to knock back the jailbars, and a DivMMC took over from tape loading. Five years on and still running.

Missing colour channelCorrupted graphics
May 2, 20212 threads