hitmanmcchitmanmcc
フィードゲーム機CRT症状テクニックLab

© 2026 Hitman's Museumv1.18.1

プロフィール·プライバシー·利用規約

Modchip / ODE

Hardware modchips, optical-drive emulators (GDEMU/ODE) and flash/IPL mods (PicoBoot).

12件の修理ログ

Sony PS1 PU-8: Green Speckles, Reflow, Recap & xStation
+23枚✓修理成功

Sony — PlayStation

Sony PS1 PU-8: Green Speckles, Reflow, Recap & xStation

Late PU-8 PlayStation, the one that gave up its xStation to a PU-18, now getting a new xStation of its own and going to a friend. It came up with random green speckles in the video output, traced to cracked, dull solder joints on the PSU. Reflowing them and swapping two capacitors cleared it. Then a full mainboard recap, with the areas around the old capacitors treated with white vinegar and cleaned with isopropyl, the old X-Reset replaced with a cleaner one on a Consoles Unleashed QSB, and finally a full recap of the power supply as well.

Corrupted graphicsBulging capacitorsCold/dull solder joints
2026年10月6日1スレッド
Sony PS1 NTSC-J: xStation, MFO, X-Reset & Blown Fuse
+49枚✓修理成功

Sony — PlayStation

Sony PS1 NTSC-J: xStation, MFO, X-Reset & Blown Fuse

Imported NTSC-J PlayStation sent in for the full works: xStation, MFO and X-Reset installs, plus a recap and a clean. Board and PSU recaps went in without trouble, then the console came up dead, no video and no audio, once the mods were fitted. The MFO had been wired to a pad that is ground on one board revision but not on this PU-18, which shorted the 3.5V rail and blew the PS604 fuse. Rewired correctly and refitted with a fuse taken from another console, with the surrounding fuses and ferrite beads checked for further damage. Finished with a controller clean and recap, lubrication and UV protectant.

Blown fuseNo video outputNo audio
2026年7月21日1スレッド
Dreamcast VA0 motherboard with removed capacitors displayed on left, showing refurbishment work in progress on circuit board.
+39枚

Sega — Dreamcast

Sega Dreamcast VA0 Recap, GDEMU & Mods (For a Friend)

Friend asked me to pick up a Sega Dreamcast VA0 from Japan and make it new again. Full recap, fan and optical drive lubrication, GDEMU install with the required VA0 resistor array mod (5V to 3.3V for GDEMU) and a dummy load resistor for the 12V PSU rail. Also fitted a resettable fuse and a fresh ML2032 clock battery.

Rust/corrosion
2025年9月29日7スレッド
Macro of the Panasonic FZ-1 mainboard's power-supply section, the area worst hit by capacitor leakage: an L4960 regulator, the silver inductor L31 (marked 101), surrounding SMD diodes and resistors, a red status LED and the Panasonic "MDFUP064" silkscreen, with the through-holes darkened and corroded from electrolyte damage.
+21枚✓修理成功

3DO Company — Panasonic FZ-1

Panasonic FZ-1 3DO: Recap & ODE (2nd, Laser Donor)

This is the Panasonic FZ-1 3DO whose laser went to save its sibling. With the drive dead anyway, a full recap and an ODE installation was the logical conclusion.

Dead laserLeaking capacitors
2023年12月4日4スレッド
Panasonic FZ-1 motherboard with multimeter probes, solder wick, and desoldering tools during PSU trace repair and recapping restoration work.
+42枚✓修理成功

3DO Company — Panasonic FZ-1

Panasonic FZ-1 3DO: PSU, Laser Swap & ODE (1st)

PSU repairs on this Panasonic FZ-1 3DO required bridging badly damaged traces, and a missed ceramic cap connection sent the console into a reboot loop. Sourcing a replacement laser meant buying a whole other console, but it runs now, and has since gained an ODE with SD card access through the AV expansion bay.

Dead laserPSU failureMagic smoke
2022年11月16日6スレッド
Three translucent bins wrapped in blue-glowing UV LED strips, set up for vapour-method retrobriting: they hold a Famicom shell and this Dreamcast's shell halves along with hydrogen peroxide, a red-capped peroxide bottle resting on top.
+21枚✓修理成功

Sega — Dreamcast

Sega Dreamcast VA0 NTSC-J: GDEMU, Recap & Dummy Load Mod

Full refurbishment of my NTSC-J Sega Dreamcast VA0: GDEMU install with the required dummy load resistor and VA0 resistor array mods, full recap, fan lube, shell clean and Aerospace 303 protectant.

2022年10月27日4スレッド
Close-up of the PS1 PSU board with the big main filter cap blown and vented, its foil wrap split open. The filter cap was the only damaged component; the transformer beside it is fine and the orange PCB is undamaged. The CD drive optical pickup sits above the board.
+38枚✓修理成功

Sony — PlayStation

Sony PS1 PU-7: Magic Smoke, xStation & Switch Fix

Don't mix PSUs with incorrect mains voltages, kids. I accidentally did that on this Sony PlayStation NTSC-J in 2022, while repairing and testing the controller ports on a friend's PAL PS1. Years later, once PU-7 QSBs finally existed, it got the mod it was bought for: an xStation from a kit by Romain Brami, with DSP pins lifted, the resistor and filter by the master clock removed, three more resistors cleared from the QSB footprint, then the QSB soldered and the FFC folded up to the top side. An X-Reset QSB followed. Shortly after, the PSU turned hard to switch on, which was corrosion inside the power switch: stripped, scraped with a fiberglass pen, cleaned with isopropyl, then DeoxIT on the contacts and grease on the plunger.

PSU failureMagic smokeRust/corrosion
2022年7月4日3スレッド
A whole black GameCube connected and powered for testing during the optical-drive recap, its amber power LED lit and its parts out of the shell: the green optical drive with the SD Media Launcher boot disc on its spindle, the controller-port PCB hanging by its flex cable, the cooling fan hanging by the wires of its power-input connector, and the PicoBoot in its 3D-printed holder suspended by its soldered wires, with several screwdrivers alongside on a wood surface.
+18枚✓修理成功

Nintendo — GameCube

Nintendo GameCube DOL-101 PAL: PicoBoot + WiiKey

PAL Nintendo GameCube DOL-101 in black, with a PicoBoot install using a WiiKey as the storage interface. The mainboard turned out to have almost entirely polymer caps, making the recap a very quick affair.

Disc read error
2022年7月1日3スレッド
Open GameCube optical drive on a wooden floor showing the exposed blue disc and orange housing, with a hand pressing the lid switches that tell the console the lid is closed, testing the drive after recapping its PCB. A Sony BVM-D9H5J monitor behind shows The Legend of Zelda: The Wind Waker.
+27枚✓修理成功

Nintendo — GameCube

Nintendo GameCube Spice Orange: PicoBoot to FlippyDrive

My personal Nintendo GameCube (DOL-001) spice orange. Started life with a PicoBoot and later upgraded to a FlippyDrive. The optical drive also got fresh caps as part of a GameCube maintenance day.

Disc read error
2022年6月30日5スレッド
Disassembled Panasonic Q optical drive rails laid out for comparison; one 3D printed replacement rail next to original shattered rail pieces.
+26枚⏳進行中

Nintendo — Panasonic Q (SL-GC10)

Panasonic Q (SL-GC10) GameCube: Drive Rails & FlippyDrive

The optical drive rails on this Panasonic Q (SL-GC10) GameCube/DVD hybrid were in pieces, so 3D-printed replacements were the first order of business. A FlippyDrive followed. Just be aware the flex cable orientation is the opposite of a regular GameCube.

Broken drive rail/gear
2022年6月25日7スレッド
Nintendo GameCube motherboard with Xeno chip installed, showing soldered connections and internal circuitry during refurbishment.
+7枚

Nintendo — GameCube

Nintendo GameCube Recap & XenoGC Mod for Two Friends

Two Nintendo GameCubes (black and spice orange) restored for friends: Console 5 mainboard cap kit, optical drive and PSU recap, XenoGC chip and new coin cell battery holders. Wind Waker was played immediately.

Disc read error
2022年6月21日2スレッド
SNK Neo Geo CD mainboard sitting inside its shell on a blue work mat, green PCB with many integrated circuits, a white ribbon cable across the centre, and the white wire work for the Furrtek Neo Geo CD SD Loader mod running across the board, with a coin-cell save battery still fitted near the bottom edge.
+16枚✓修理成功

SNK — Neo Geo CD

SNK Neo Geo CD: Full Recap, PSU, SD Loader & F-RAM Save Mod

A cheap Neo Geo CD from 2021, recapped board by board: the AV and power board, the optical drive PCB, the mainboard and the original PSU. Later fitted with a NEO SD Loader to take the load off the drive, and an F-RAM save mod after it stopped holding saves even with a fresh battery.

Leaking capacitorsBattery-backed save loss
2021年1月17日3スレッド