hitmanmcchitmanmcc
InicioConsolasCRTsSíntomasTécnicasLab

© 2026 Hitman's Museumv1.18.1

Acerca·Privacidad·Términos
Consolas/Nintendo/AV Famicom

Nintendo — AV Famicom

Nintendo AV Famicom (HVC-101) Recap, 7805 & Clean

11 de septiembre de 20252 hilos~1 min de lectura
Gray/blank screen on bootCartridge slot oxidation
RecapVoltage-regulator swap

This Nintendo AV Famicom (HVC-101) arrived with a gray screen and a catastrophically oxidised cartridge slot. A good clean fixed the boot issue; a full recap and 7805 voltage regulator replacement took care of the rest.

Piezas y Herramientas (2)

EverDrive N8 Pro (72-pin NES)

EverDrive N8 Pro by krikzz, the 72-pin NES flashcart, run on this 60-pin AV Famicom through a 72-to-60-pin cartridge adapter (the same setup used on the Sharp Twin Famicom). Used to run games during testing.

DeoxIT contact cleaner

DeoxIT by CAIG Laboratories, the go-to contact cleaner for oxidation on consoles, cartridges and connectors, used here on the oxidised cartridge slot.

hitmanmcc
hitmanmcc

11 de septiembre de 2025· Hilo 1

Ver en X ↗Ver en Bluesky ↗

The AV Famicom that arrived yesterday wasn't booting up games. It would come up with a gray screen. I went for the easy cause first. So, I cleaned the cartridge slot and it worked. It turned out to have a massive amount of oxidation. #Nintendo #NES #Famicom #Castleva #RETROGAMING

hitmanmcc
hitmanmcc

11 de septiembre de 2025· Hilo 2· 3 tweets

Ver en X ↗Ver en Bluesky ↗

1/3 Opened up the AV Famicom for maintenance. It was somewhat dusty, not too bad but, enough for it to mix with the deoxit I had sprayed yesterday and make a mess. #Nintendo #Famicom #restoration #RETROGAMING

2 / 3

2/3 Recapped and cleaned the board, couldn't match all the caps in physical size from what I have lying around but there's no clearance issues. Also cleaned the inside of the shell and the board after the recap. Reflowed the pins of the power jack too.

3 / 3

3/3 Finished it off with some #Castlevania.

Reparaciones relacionadas

Two Nintendo Game Boy Player (DOL-017) units seen from their top side (the side that docks to the GameCube) on paper towel, a silver one and an indigo one, each with a sealed Console5 GameCube GB Player cap kit bag (NIN-GC-GBPLAYER-SMD-CK) resting on it, and an FNIRSI soldering iron in its case to the right.

Nintendo — Game Boy Player

Nintendo Game Boy Player (DOL-017) Recap: Leaking Caps

Super Famicom motherboard mid-repair: recapped with new capacitors, voltage regulator replaced, some SMD components remaining; soldering iron and loose components visible on workbench.

Nintendo — Super Famicom

Nintendo Super Famicom Recap & Voltage Regulator Swap

Super Famicom Jr. motherboard on workbench with purple mod board installed, soldering iron, wire strippers, and solder spool visible during repair work.

Nintendo — Super Famicom Jr.

Nintendo Super Famicom Jr. (SHVC-101) Recap & Upgrades

Nintendo Game Boy Light (MGB-101): Battery Leak & Recap

Nintendo — Game Boy Light

Nintendo Game Boy Light (MGB-101): Battery Leak & Recap

Nintendo 64 motherboard with capacitors removed during recapping repair, alongside SMD cap kit and organized replacement capacitors on work surface.

Nintendo — Nintendo 64

Nintendo 64 (NUS-001) Full Recap: Childhood Console

Nintendo DMG Game Boy PCBs during recap repair: green mainboard with new capacitors installed, donor board right, service card visible below.

Nintendo — Game Boy

Nintendo Game Boy DMG-01 Recap & Clean (2nd Unit)