hitmanmcchitmanmcc
InicioConsolasCRTsSíntomasTécnicasLab

© 2026 Hitman's Museumv1.18.1

Acerca·Privacidad·Términos

▸ SYSLOG ACTIVE — REPAIR ARCHIVE ONLINE

@hitmanmcc▌— Repair logs by @hitmanmcc: consoles, CRTs, and lab notes

— Hitman's Museum of Consoles & CRTs

Donde las consolas muertas vuelven a la vida — restaurando, modeando y preservando hardware retro.

122repairs documented·LIVE
display
Nintendo Game Boy Light (MGB-101): Battery Leak & Recap
+11 fotos✓Reparación exitosa

Nintendo — Game Boy Light

Nintendo Game Boy Light (MGB-101): Battery Leak & Recap

A Game Boy Light that still worked, but carried the scars of batteries left to leak inside it for years. Cleaned up and recapped with a Console5 kit that had been waiting on the shelf for exactly this day.

Rust/corrosionBattery leakage damage
2 nov 20261 hilo
Sony PS1 PU-8: Green Speckles, Reflow, Recap & xStation
+23 fotos✓Reparación exitosa

Sony — PlayStation

Sony PS1 PU-8: Green Speckles, Reflow, Recap & xStation

Late PU-8 PlayStation, the one that gave up its xStation to a PU-18, now getting a new xStation of its own and going to a friend. It came up with random green speckles in the video output, traced to cracked, dull solder joints on the PSU. Reflowing them and swapping two capacitors cleared it. Then a full mainboard recap, with the areas around the old capacitors treated with white vinegar and cleaned with isopropyl, the old X-Reset replaced with a cleaner one on a Consoles Unleashed QSB, and finally a full recap of the power supply as well.

Corrupted graphicsBulging capacitorsCold/dull solder joints
6 oct 20261 hilo
Sharp X68000 XVI Compact: Cut PSU Cord & Full Recap
+41 fotos⏳En progreso

Sharp — X68000 XVI Compact

Sharp X68000 XVI Compact: Cut PSU Cord & Full Recap

Won at auction with its mains cord cut clean off the PSU, taken as a gamble at a below-market price. A replacement lead was spliced in from another Japanese cord using solder-ring heatshrink sleeves, with extra insulation over the joint. It powered on once, then refused entirely, so the PSU came out for a recap: fully decapped, scrubbed with white vinegar and isopropyl, new capacitors fitted and marked, and every joint on the solder side reflowed. That brought it back reliably and it booted Human68k from disk. The rest of the machine was worse, with electrolyte contamination on every capacitor pad on every board. SMDs came off the mainboard and the expansion card, the pads were reworked with fresh solder, flux and braid until all were clean and none lost, then the through-hole electrolytics followed. The floppy drives had leaked internally and were recapped with their motor shafts cleaned and lubricated, and the peripheral input board's single capacitor was replaced. Still powers on after reassembly, pending fuller testing.

No powerLeaking capacitorsCapacitor leakage damage
1 ago 20262 hilos
Victor RG-M1 Wondermega: Dead Laser, RGB Mod & Recap
+84 fotos✓Reparación exitosa

Sega — Wondermega

Victor RG-M1 Wondermega: Dead Laser, RGB Mod & Recap

Someone else's Victor RG-M1 Wondermega, JVC's branding of the Sega Wondermega, sent in for refurbishment and described as fully functional. It arrived with a blown supercapacitor and a loose capacitor rattling around inside the shell, later traced to a pad beside the DC input jack where the machine had taken a hard knock. Carts played happily but it would not read a single CD. A full recap followed, roughly 70 capacitors across every board, with white vinegar and isopropyl baths, flux and fresh solder over dodgy vias and the regulators, and DeoxIT through the karaoke pots and microphone jacks. The cart side came back fine, the CD side did not. A detour along the way cured the vertical jailbars on the composite and S-video outputs with an Oleg Endo RGB kit, tapping the Sony CXA1145M encoder and swapping the stock S-video port for a Saturn-style DIN. The supercapacitor was replaced and later superseded by an F-RAM install. The CD fault survived a complete chassis swap, a clean bill of health on every board and a working spindle motor, which left the laser. The owner sourced new old stock, and once it was fitted and its board recapped in turn, the machine read both originals and backups. Finished with UV protectant and packed up.

Dead laserDisc read errorJailbars+1
23 jul 20261 hilo
Sony PS1 NTSC-J: xStation, MFO, X-Reset & Blown Fuse
+49 fotos✓Reparación exitosa

Sony — PlayStation

Sony PS1 NTSC-J: xStation, MFO, X-Reset & Blown Fuse

Imported NTSC-J PlayStation sent in for the full works: xStation, MFO and X-Reset installs, plus a recap and a clean. Board and PSU recaps went in without trouble, then the console came up dead, no video and no audio, once the mods were fitted. The MFO had been wired to a pad that is ground on one board revision but not on this PU-18, which shorted the 3.5V rail and blew the PS604 fuse. Rewired correctly and refitted with a fuse taken from another console, with the surrounding fuses and ferrite beads checked for further damage. Finished with a controller clean and recap, lubrication and UV protectant.

Blown fuseNo video outputNo audio
21 jul 20261 hilo
PC Engine LT board (component side) on a paper towel with the Ext Bus connector desoldered and resting above it, exposing the electrolyte and grime caked on the board where the connector had sat.
+34 fotos✓Reparación exitosa

NEC — PC Engine LT

NEC PC Engine LT Recap + LCD Bias Fix (Necromancy)

An epic of strife, perseverance and adaptation. The NEC PC Engine LT is the 1991 laptop-format PC Engine with a built-in colour LCD. Almost always dead from cap leakage. This one needed a full recap, a new voltage regulator, and an off-the-shelf voltage inverter module to replace the T500 LCD bias transformer, killed by the electrolyte. Without that, the screen stays dark.

No powerNo video outputLeaking capacitors+2
26 ene 20261 hilo
Victor RG-M1 motherboard during recap with visible capacitor leakage near voltage regulators and fresh solder joints from board restoration work.
+11 fotos

Sega — Wondermega

Victor RG-M1 Wondermega Full Board Recap & Laser Clean

Full board recap on this Victor RG-M1 Wondermega (JVC's branding of the Sega Wondermega), complete with a laser sled clean. Drew blood for this one; photo evidence in the thread. Everything works; the motorised tray is just waiting on a replacement belt.

Broken/worn drive beltDisc tray won't open
22 ene 20261 hilo
PC Engine CD-ROM2 internal mechanism with the laser assembly, motor, PCB and wiring on the white plastic chassis, showing the shaft where the old crumbling gear sat and where the new 3D-printed replacement gear was about to be fitted.
+18 fotos✓Reparación exitosa

NEC — PC Engine CD-ROM2

NEC PC Engine CD-ROM² Restoration: Gears, Laser & Recap

This NEC PC Engine CD-ROM² threw everything at me: 3D printed gears, a dead laser, a Discman sacrifice and a spindle height mystery, before a full recap finally brought it home. Worth every frustrating hour of it.

Dead laserDisc read errorBroken drive rail/gear+1
28 dic 20254 hilos
The NEC IFU-30 mainboard, now recapped, with the old capacitors in a bowl.
+7 fotos

NEC — PC Engine IFU-30

NEC PC Engine IFU-30 Recap: Caps, Regulator & Supercap

Capacitors, voltage regulator and the supercapacitor that keeps the save data alive on this NEC PC Engine IFU-30 interface unit. Validated with Street Fighter II and Bomberman '94.

Battery-backed save loss
19 dic 20251 hilo
NEC PC Engine CoreGrafx mainboard before the recap, held in hand, dust and fluff over the board, with the ICs, voltage regulator (under its metal heatsink bracket) and the metal-can crystal oscillator visible.
+6 fotos

NEC — PC Engine CoreGrafx

NEC PC Engine CoreGrafx Recap, 7805 & Jailbar Fix

A quick pre-dinner recap on this NEC PC Engine CoreGrafx, plus the standard 7805 voltage regulator replacement and jailbar fix caps thrown in for good measure. Short job.

Jailbars
15 dic 20251 hilo
NEC Ten No Koe 2 battery compartment showing original Hudson Soft branded batteries after removal during recap repair.
+3 fotos

NEC — Ten No Koe 2

NEC Ten no Koe 2 Archaeological Find: Hudson Soft Batteries

This NEC Ten no Koe 2 was harbouring what are probably the original Hudson Soft branded batteries, in there since the day it left the factory. No leakage, so the batteries were kept as-is; the compartment got a preventative treatment anyway in case of past leakage.

9 dic 20251 hilo
Burnt X2 safety capacitor held in fingers, showing catastrophic thermal damage and charring from the Beovision 1 repair.
+33 fotos✓Reparación exitosa

Bang & Olufsen (B&O) — Beovision 1

Bang & Olufsen Beovision 1: X2 Safety Cap Magic Smoke

This Bang & Olufsen Beovision 1 CRT TV had the audacity to emit smoke and then carry on displaying a perfect picture. A lengthy investigation eventually uncovered an X2 safety cap that had met a truly spectacular end. Came away with a cleaner TV and a great story.

PSU failureMagic smokeCold/dull solder joints
8 dic 20253 hilos