Metal parts or PCB oxidised, typically from moisture exposure.
11 Protokolle
Nintendo — Game Boy Light
A Game Boy Light that still worked, but carried the scars of batteries left to leak inside it for years. Cleaned up and recapped with a Console5 kit that had been waiting on the shelf for exactly this day.
A very cheap PS5 Media Remote with leaked batteries and corroded battery contacts. After a soak in white vinegar and Evaporust, some work with a fibreglass pen and a run in the ultrasonic, it works again. The nickel plating on the contacts has seen better days.
My brother's RC car from when we were kids, with leaked batteries that had rotted the battery contacts. I recapped and deep cleaned the controller and serviced the motor and steering gears. The original contacts were too far gone even after vinegar and Evaporust, so I replaced them with new ones. The car still wouldn't run, until it turned out the new contacts have slightly different tolerances and one battery wasn't fully seated. Pushing it all the way in brought the car back to life.
Two very grotty PS4 controllers, one of them drifting. The drift was fixed with nothing more than a thorough cleaning of the potentiometer wiper, and the rusted rumble motors came up reasonably well after an Evaporust soak.
Sega — Dreamcast
Friend asked me to pick up a Sega Dreamcast VA0 from Japan and make it new again. Full recap, fan and optical drive lubrication, GDEMU install with the required VA0 resistor array mod (5V to 3.3V for GDEMU) and a dummy load resistor for the 12V PSU rail. Also fitted a resettable fuse and a fresh ML2032 clock battery.
Sharp — X68000
A proper exercise in stubbornness on this Sharp X68000. Two rounds of repair, a full recap, FDD surgery (one of the floppy drives had clear signs of a blown capacitor with charring on the PCB), a new oscillator, and still no picture. The X68000 remains on the 'future date' pile.
Microsoft — Xbox 360 E
The Microsoft Xbox 360 E's PSU was packed with bargain-bin caps and the board had clearly had something spilled on it. A recap, a reflow, a fresh HDD and some elbow grease on the shell later, it's a much happier machine.
Ikegami — HTM-1005RA2
Ikegami HTM-1005RA2 broadcast monitor acquired alongside a Victor monitor; both had one hell of a rough ride in transit. Fortunately this one fared a lot better than the Victor.
Victor — TM-A101
Victor TM-A100 broadcast monitor acquired alongside an Ikegami; both had one hell of a rough ride in transit. Sadly this one fared a lot worse than the Ikegami.
Sony — PlayStation
Don't mix PSUs with incorrect mains voltages, kids. I accidentally did that on this Sony PlayStation NTSC-J in 2022, while repairing and testing the controller ports on a friend's PAL PS1. Years later, once PU-7 QSBs finally existed, it got the mod it was bought for: an xStation from a kit by Romain Brami, with DSP pins lifted, the resistor and filter by the master clock removed, three more resistors cleared from the QSB footprint, then the QSB soldered and the FFC folded up to the top side. An X-Reset QSB followed. Shortly after, the PSU turned hard to switch on, which was corrosion inside the power switch: stripped, scraped with a fiberglass pen, cleaned with isopropyl, then DeoxIT on the contacts and grease on the plunger.
Microsoft — Xbox
Taking a heavily rusted original Microsoft Xbox back to glory: full recap, optical drive belt replacement, metal parts soaked in a vinegar bath for days, Dremel-sanded clean, then finished with matte galvanizing paint to stop the rust returning. Later softmodded with Rocky5's Xbox Softmodding Tool.